ADC

Configure a load balancing method that does not include a policy

September 14, 2021

Contributed by:

S C

After you select a load balancing algorithm for your load balancing setup, you must configure the Citrix ADC appliance to use that algorithm. You can configure it by using the CLI or by using the configuration utility.

Note:

The token method is policy based and requires more configuration than is described here. To configure the token method, see Token method.

For some hash-based methods, you can mask an IP address to direct requests belonging to the same subnet to the same server. For more information, see Hashing methods.

To set the load balancing method by using the command line interface

At the command prompt, type:

set lb vserver <name> -lbMethod <method>
<!--NeedCopy-->

Example:

set lb vserver Vserver-LB-1 -lbMethod LeastConnection
<!--NeedCopy-->

To set the load balancing method by using the configuration utility

Navigate to Traffic Management > Load Balancing > Virtual Servers, and open a virtual server.
In Advanced Settings, click Method, and in the Load Balancing Method list, select a method.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Configure a load balancing method that does not include a policy

September 14, 2021

Contributed by:

S C

September 14, 2021

Contributed by:

S C

Configure a load balancing method that does not include a policy

To set the load balancing method by using the command line interface

To set the load balancing method by using the configuration utility

In this article