ADC

Configuring Bridge Groups

September 14, 2021

Contributed by:

Typically, when you want to merge two or more VLANs into a single domain, you change the VLAN configuration on all the devices in the separate domains. This can be a tedious task. To more easily merge multiple VLANs into a single broadcast domain, you can use bridge groups.

The bridge groups feature works the same way as a VLAN. Multiple VLANS can be bound to a single bridge group, and all VLANs bound to same bridge group form a single broadcast domain. You can bind only Layer 2 VLANs to a bridge group. For Layer 3 functionality, you must assign an IP address to a bridge group.

In Layer 2 mode, a broadcast packet received on an interface belonging to a particular VLAN is bridged to other VLANs that belong to the same bridge group. In the case of a unicast packet, the Citrix ADC appliance searches its bridge table for the learned MAC addresses of all the VLANs belonging to same bridge group.

In Layer 3 forwarding mode, an IP subnet is bound to a bridge group. The Citrix ADC accepts incoming packets belonging to the bound subnet and forwards the packets only on VLANs that are bound to the bridge group.

IPv6 routing can be enabled on a configured bridge group.

Note

Bridge Group feature and Bridge BPDU mode cannot work together.

Configuration steps

Perform the following steps to configure a bridge group:

Enable Layer 2 mode
Add a bridgegroup and bind VLANs to the bridgegroup

CLI procedures

To enable Layer 2 mode by using the CLI: At the command prompt, type:

enable ns mode l2
show ns mode

To add a bridge group and bind VLANs by using the CLI:

At the command prompt, type:

**add bridgegroup** <id> [-**ipv6DynamicRouting** ( **ENABLED** | **DISABLED** )]
bind bridgegroup <id> -vlan <positive_integer>
show bridgegroup <id>

Example:

> add bridgegroup 12
 Done
<!--NeedCopy-->

To remove a bridge group by using the CLI:

At the command prompt, type:

rm bridgegroup <id>

Example:

 rm bridgegroup 12
<!--NeedCopy-->

GUI Procedures

To configure a bridge group by using the GUI:

Navigate to System > Network > Bridge Groups, add a new bridge group and bind VLANs to the bridgegroup, or edit an existing bridge group.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Configuring Bridge Groups

September 14, 2021

Contributed by:

September 14, 2021

Contributed by:

Configuring Bridge Groups

Configuration steps

CLI procedures

GUI Procedures

In this article