ADC

Retain the VLAN identifier for VLAN transparency

April 19, 2021

Contributed by:

C S

You can configure a load balancing virtual server to retain the client’s VLAN identifier in packets that are to be forwarded to servers. The virtual server must be a wildcard virtual server of type ANY, and must be functioning in MAC mode.

To configure a load balancing virtual server to retain the client VLAN ID by using the CLI

At the command prompt, type the following command to configure a load balancing virtual server to retain the client VLAN ID and verify the configuration:

set lb vserver <name> -m MAC -macmodeRetainvlan ENABLED

show lb vserver <name>
<!--NeedCopy-->

Note

For a service that is bound to a virtual server on which the -m MAC option is enabled, you must bind a non-user monitor.

To configure a load balancing virtual server to retain the client VLAN ID by using the GUI

Navigate to Traffic Management > Load Balancing > Virtual Servers, and open a virtual server.
In Advanced Settings, select Traffic Settings, and select Retain VLAN ID.

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Was this helpful

Retain the VLAN identifier for VLAN transparency

April 19, 2021

Contributed by:

C S

April 19, 2021

Contributed by:

C S

Retain the VLAN identifier for VLAN transparency

To configure a load balancing virtual server to retain the client VLAN ID by using the CLI

To configure a load balancing virtual server to retain the client VLAN ID by using the GUI

In this article