ADC

Content Switching for Diameter Protocol

August 20, 2024

Contributed by:

C C

For Diameter-protocol traffic, you can configure the Citrix ADC appliance (or virtual appliance) to act as a relay agent that load balances and forwards a packet to the appropriate destination on the basis of the message content (AVP value in the message). Since the appliance does not perform any application-level processing, it provides relaying services for all diameter applications as specified by the configured content switching policies. Therefore, the appliance advertises the Relay Application ID in the capability exchange answer (CEA) message when the client establishes a diameter connection. You must configure a content switching virtual server, load balancing virtual servers, and services to represent the diameter nodes. When a request reaches the content switching virtual server, the virtual server applies the content switching policies associated with that type of request. After evaluating the policies, the content switching virtual server routes the request to the appropriate load balancing virtual server, which sends it to the appropriate service.

A diameter interface provides a connection between the different diameter nodes. The following sample deployment uses Cx and Rx interfaces. A Cx interface provides a connection between a CSCF and an HSS. An Rx interface provides a connection between a CSCF and a PCRF. All the messages reach the Citrix ADC appliance. Depending on whether the message is for a Cx or an Rx interface, and on the content switching policies defined, the Citrix ADC selects an appropriate load balancing server pool.

localized image

Sample Configuration

For each entity, create a service, a load balancing server, and bind the service to the virtual server.

add service svc_pcrf[1-3] 1.1.1.1[1-3] DIAMETER 3868
add service svc_hss[1-3] 1.1.1.2[1-3] DIAMETER 3868
add lb vserver vs_rx DIAMETER -persistenceType DIAMETER –persistavpno 263
add lb vserver vs_cx DIAMETER -persistenceType DIAMETER –persistavpno 263
bind lb vserver vs_rx svc_pcrf[1-3]
bind lb vserver vs_cx svc_hss[1-3]
<!--NeedCopy-->

Create a content switching virtual server and two actions (one for each load balancing virtual server). Create two content switching policies and bind these policies to the content switching virtual server, specifying a priority for each policy.

add cs vserver cs_diameter DIAMETER 10.1.1.10 3868
add cs action cx_action -targetLBVserver vs_cx
add cs action rx_action –targetLBvserver vs_rx
add cs policy cx_policy -rule "DIAMETER.REQ.AUTH_APPLICATION_ID.EQ(16777216)" -action cx_action
add cs policy rx_policy -rule "DIAMETER.REQ.AUTH_APPLICATION_ID.EQ(16777236)" -action rx_action
bind cs vserver cs_diameter -policyName rx_policy -priority 100
bind cs vserver cs_diameter -policyName cx_policy -priority 110
<!--NeedCopy-->

The official version of this content is in English. Some of the Cloud Software Group documentation content is machine translated for your convenience only. Cloud Software Group has no control over machine-translated content, which may contain errors, inaccuracies or unsuitable language. No warranty of any kind, either expressed or implied, is made as to the accuracy, reliability, suitability, or correctness of any translations made from the English original into any other language, or that your Cloud Software Group product or service conforms to any machine translated content, and any warranty provided under the applicable end user license agreement or terms of service, or any other agreement with Cloud Software Group, that the product or service conforms with any documentation shall not apply to the extent that such documentation has been machine translated. Cloud Software Group will not be held responsible for any damage or issues that may arise from using machine-translated content.

Content Switching for Diameter Protocol

August 20, 2024

Contributed by:

C C

August 20, 2024

Contributed by:

C C

Content Switching for Diameter Protocol

Sample Configuration

In this article