ADC

Configuring Multiple VLANs with 802.1q Tagging

For multiple VLANs with 802.1q tagging, each VLAN is configured with a different IP subnet. Each network interface is in one VLAN. One of the VLANs is set up as tagged. The following figure shows this configuration.

Figure 1. Multiple VLANs with IEEE 802.1q Tagging

vlan tagging

To implement the configuration shown in the above figure, perform the following tasks:

  1. Add VLAN 2.
  2. Bind the 1/2 network interface of the Citrix ADC to VLAN 2 as an untagged network interface.
  3. Bind the IP address and netmask to VLAN 2.
  4. Add VLAN 3.
  5. Bind the 1/2 network interface of the Citrix ADC to VLAN 3 as a tagged network interface.
  6. Bind the IP address and netmask to VLAN 3.

For procedures on these tasks, see Configuring a VLAN.

Configuring Multiple VLANs with 802.1q Tagging